Make successful fishing knots

Simple, sturdy and easy to execute, this basic knot can effectively attach flexible lure, crankbait, swivel, fly, etc.

Step 1: pass the wire through the eye of the hook.
Step 2:form a small loop then wind the wire around the line (5/6 times).
Step 3: pass the wire back through the loop.
Step 4:wet the wire with saliva before tightening it then cutting off the excess..

This is a knot of very high strength and which is non-slip. It can be used to connect the line to a swivel, a hook eyelet, a crankbait, jighead...

Step 1:double up the line before passing it through the eye.
Step 2: tie a simple knot.
Step 3: pass the object (hook, swivel) through the loop and tighten gradually.

This knot allows you to attach any spade-end hooks of any size. This is a knot that any still fisherman should know.

Step 1: form a loop at the shank of the hook.
Step 2: hold the loop using your thumb and index finger and wrap the wire around the shank (6-7 turns).
Step 3: Moisten the wire before tightening the knot by pulling on the wire on the side of the spade-end.

Do you need to connect the body of your line to your leader? Here is our selection of reliable and simple knots to execute.

This single knot can effectively connect two wires of similar diameter. It is not recommended for connecting the braid with wire or nylon-type fluorocarbon as the braid tends to sever the wire.

Step 1: place the two strands in parallel.
Step 2: make a loop with the two wires.
Step 3: pass the two strands inside the loop. Repeat the process 2 times.
Step 4: moisten the knot with saliva and tighten it gradually

This is a very effective knot for connecting the braid to nylon or fluorocarbon or for connecting two wires of different diameters. It slides excellently inside the rings.

Step 1: make a figure of eight with your nylon or fluorocarbon wire.
Step 2: thread the body through the loop.
Step 3: wind it round fifteen times in one direction before coming back to the loop and making the same number of turns in the other direction.
Step 4: pass the wire back through the loop.
Step 5: wet the knot with saliva and tighten it gradually. Cut off the surpluses.

This is a simple and effective basic knot that quickly connects the main line to the leader.

Step 1: make a loop at the end of your main line.
Step 2: Loop the main line through the loop of the leader.
Step 3: Thread the end of the leader through the loop of the leader before tightening it.

A dropper knot enables you to attach an extra soft lure, floating jig, feather, live bait, etc.

This rig enables you to attach an extra soft lure, floating jig, feather, etc.

Step 1 : placing the two strands in parallel at the dropper.
Step 2: execute a classic surgeon's knot.
Step 3:: cut the unwanted strand for your dropper knot..